 | Anwendung | ATTENTION, PLEASE NOTE Before application, please read the safety instructions on the back side of the instruction leaflet carefully. 1. PREPARATION: Before starting the application, place a clothing protection and a watch nearby so that you can monitor the application time. SYOSS COLOR is to be used on dry, not pre-washed hair. 2. MIXING: Put on the clothing protection and the gloves supplied. Unscrew the cap of the applicator bottle. Open the color cream tube by piercing the tube sealing with the reverse side of the cap. Squeeze the whole content of the tube into the applicator bottle. Close the applicator bottle again and shake it vigorously until all components are thoroughly mixed and turned into a smooth cream. Finally, break off the tip of the applicator nozzle and start with the application immediately. ATTENTION: The color of the mixture of some shades changes during the application process. This has no impact on the color result. 3A. TOTAL APPLICATION: Apply the prepared coloration mixture strand after strand on the whole hair, then spread it thoroughly. Allow the coloration mixture to work for 30 minutes. Leave in for 45 minutes. Developing time depends on shade. 3B RE-GROWTH APPLICATION: Apply the prepared coloration mixture directly from the applicator bottle on dry, not prewashed hair. This application is necessary if: • your hair is already colored permanently, and a re-growth is visible, or • your hair tips are darker or in poor condition. Apply about ⅔ of the coloration mixture only on the re-growth area. For this, make a parting with the top of the applicator bottle and apply the mixture along the parting by spreading it into the roots with your fingertips (leave supplied gloves on). Repeat this procedure for the whole re-growth area. Allow the coloration mixture to work for 20 minutes. Apply the rest of the mixture in the whole hair and allow it to work for a further 10 minutes. The processing time of the coloration mixture to the new roots should be 35 minutes. 4. RINSING & AFTER TREATMENT: At the end of the application time, apply warm water to the hair and work into lather. Then rinse out thoroughly until water runs clear. Finally, shampoo your hair and rinse out thoroughly. As a subsequent care treatment, apply the SYOSS Intense Plex Deep Conditioner into the wet hair. Allow to work for 2 minutes and then rinse out thoroughly. The SYOSS Intense Plex Deep Conditioner cares for the hair and ensures healthy-shiny hair with less hair breakage * for brilliant shine and color intensity. |